Liner Problems

I have a 24 ft round pool. I have had some trouble putting it up. I have had to take it down three times. I now have the pool ready to finish this time. But, when I put the liner up this time I have a crap load of twists in the wall part.

I have tried to pull them out at the base and the wall but it just does not seem to do anything. Do you think I need to replace the liner and start new, or is there a way to get the twists out of the liner?



Hi. If the liner is new, as in never been filled with water and never had a skimmer hole cut, I would go ahead and use it. The best way to install a liner into an above ground pool is to stretch it. There pages show how that is done.

Above Ground Pool Liner Installation

Expandable Liner Installation

If the liner has the skimmer opening cut, and you are trying to line that back up, the best I can say is to make use of the sun and try it during the hottest part of the day. Vinyl is much easier to work with when it's hot.





Make good use of cloths pins, they help a lot.