Parts

by Norma
(Manton Michigan)

Artesian Bottom Plate

I Need only one does anyone know where I can locate one? It is a bottom plate for an Artesian Monico Elite pool series ME10-52W frame series 6500.

Parts

by: CJEllerbe

I have been communicating with Artesian Pools and Spas which moved from Baltimore the PA. artesianyork@hotmail.com is their email address. They seem to be a bit expensive though. I am looking for top and bottom rails after the storm Friday night damaged the frame. Good Luck & God Bless!

Needed Top Cap and Bottom Rail Clip

by Tammy
(Pierson, Mi)

I have purchased an older round pool. Supposedly a Doughboy. Some of the parts are missing. I need 8 top caps -part number 078-050106. I also need bottom rail clips. Can anybody help me. Thanks

Top Rails For Older Pool

by Kelly
(Monticello, AR)

I have an older pool that the walls are like a hard plastic and it takes a liner with a top rail system to hold the liner in place. It is probably 7 or 8 years old. I am needing the top trim/rail that goes on the top to hold the liner in place. Can you help?

thanks, Kelly

Plastic Top Rails

by Liz
(Union City, Tn)

The top rails on our pool need replaced BAD! We have an Outback - above ground pool. And after buying our house we discovered that the previous owners put duck tap on the top rails hiding all the rust. They had a salt water system which I don't know too much about pools but, I know a salt water system is NEVER a good idea with an above ground pool.

The tops we currently have are metal and I am trying to find plastic ones. We have 2 girls and I would rather them not burn themselves on metal tops! I have been looking EVERYWHERE and have had not luck. Can anyone help me find plastic top rails?

Foot Plate/Joint

by Cindy
(Wisconsin)

I'm trying to find a foot plate with the number T 2990. Unfortunately I do not know the pool manufacturer as it is in pieces! Any help would be appreciated!

Southwind Pool Parts

by Brian
(Convoy, Ohio)

I need the top stabilizer bars for Southwind 15x30 Oval pool, it was purchased in Lima, Ohio 10 yrs ago from a dealer. I've asked on two occasions if I can get new Bars and neither time have they given me an answer other than the Manufacturer has not gotten back with them. So if no one knows where to find them can someone at least tell me who the manufacturer is so I can contact them myself.

Bottom Rails and Plates

by Darla

I was wondering if you can help me. I bought a 24 foot round pool with 48 inch walls. I do not know the manufacturer. I need to find bottom rails and a few plates for it. Can you help me? I have attached pictures. Thanks

Swim and Play - Yukon 24ft x 52 in

by Mark Smith
(Somerset, Pennsylvania)

I am in desperate need of the 6 inch resin plate that sits on top of the wall braces. The issue is that the resin tends to snap. I would prefer to have this same piece in metal. It is my understanding that Swim and Play went out of business in 2018 and that these parts are very hard to find. Any help would be greatly appreciated.